Costumes Fabric Painting & Dyeing Leatherwork Other Textile Projects Quilting Ribbon Crafts Sewing Weaving

How to Cut a Ribbon so it Doesn't Fray

How to Cut a Ribbon so it Doesn't Fray

How to Cut a Ribbon so it Doesn't Fray. Whether you're wrapping presents, decorating, participating in grade school art class, or dedicating that new hospital you have built as a charitable tax write off, ribbon cutting is as close to a universal human crafting experience as one can get. As such, every time a ribbon is cut, the same peril arises:...

Whether you're wrapping presents, decorating, participating in grade school art class, or dedicating that new hospital you have built as a charitable tax write off, ribbon cutting is as close to a universal human crafting experience as one can get. As such, every time a ribbon is cut, the same peril arises: the dreaded fray. Nothing can so effectively ruin what is intended to be the final piece of flair on a project than the unkempt ends of a ribbon falling apart.
Things You'll Need
Sharp scissors
Ribbon
Clear "Scotch" tape
Candle
Iron
Clear-drying glue
Hairspray
Clear nail polish
Cutting the Edge
Determine where and how you wish to cut the ribbon. Note that angled cuts are, in general, less likely to fray.
Place clear tape over the site of your intended cut. With the sharpest scissors possible, cut the ribbon through the tape.
Remove the tape after cutting to expose the newly trimmed edge.
Options for Sealing Synthetic Ribbons
Hold the newly cut edge approximately 1/4-inch from the candle, allowing the heat from the flame to slightly melt the end of the ribbon. Be careful not to set the ribbon on fire!
Run a hot iron quickly over the edge you have just made. Use a medium heat setting, to avoid melting the ribbon. If you are using an iron without variable settings, place a paper towel between the iron and the ribbon as you sear the edge.
Practice these techniques on a non-essential piece of the same ribbon to determine the speed at which you will move the iron.
Options for Sealing Any Ribbon Type
Apply a small amount of clear-drying craft glue to the cut end of the ribbon. Remove any excess so that the end of the ribbon is only slightly dampened.
Spray the end of the ribbon with hair spray to seal the cut edge. Test the hairspray on a non-essential piece of the same ribbon to determine possible color side effects.
Apply a small amount of clear nail polish to the end of the ribbon. Test the nail polish on a non-essential piece of the same ribbon to determine possible color side effects.

Check out these related posts